Security Center 5.7 System Requirements Guide

8m ago
54 Views
0 Downloads
249.38 KB
14 Pages
Transcription

Security Center System RequirementsGuide 5.7Document last updated: Octber 16, 2017

Copyright notice Genetec Inc., 2017Genetec Inc. distributes this document with software that includes an end-user license agreement and isfurnished under license and may be used only in accordance with the terms of the license agreement. Thecontents of this document are protected under copyright law.The contents of this guide are furnished for informational use only and are subject to change withoutnotice. Genetec Inc. assumes no responsibility or liability for any errors or inaccuracies that may appear inthe informational content contained in this guide.This publication may not be copied, modified, or reproduced in any form or for any purpose, nor can anyderivative works be created therefrom without Genetec Inc.’s prior written consent.Genetec Inc. reserves the right to revise and improve its products as it sees fit. This document describes thestate of a product at the time of document’s last revision, and may not reflect the product at all times in thefuture.In no event shall Genetec Inc. be liable to any person or entity with respect to any loss or damage that isincidental to or consequential upon the instructions found in this document or the computer software andhardware products described herein. The use of this document is subject to the disclaimer of liability foundin the end-user license agreement.Genetec, Genetec Clearance, Omnicast, Synergis, AutoVu, Federation, Stratocast, Sipelia, Citywise, GenetecRetail Sense, Genetec Traffic Sense, Genetec Airport Sense, Genetec Motoscan, Genetec Citigraf, GenetecMission Control, Genetec ClearID, Genetec Patroller, Community Connect, the Genetec Logo, the MobiusStrip Logo, the Genetec Clearance Logo, the Omnicast Logo, the Synergis Logo, the AutoVu Logo, and theStratocast Logo are trademarks of Genetec Inc., and may be registered or pending registration in severaljurisdictions. Other trademarks used in this document may be trademarks of the manufacturers or vendorsof the respective products.All specifications are subject to change without notice.Document informationDocument title: Security Center System Requirements Guide 5.7 SR4Document number: EN.500.100-V5.7.B(1)Document update date: Octber 16, 2017You can send your comments, corrections, and suggestions about this guide [email protected]

1Security Center System RequirementsThis section includes the following topics:10 "Security Center 5.7 client station requirements" on page 2 "Maximum number of cameras viewed per client type" on page 3 "Security Center 5.7 server requirements" on page 4 "Maximum number of cameras and readers per server type" on page 5 "Security Center 5.7 AutoVu LPR server requirements" on page 7 "Security Center 5.7 software requirements" on page 8 "Additional considerations for server specifications in Security Center 5.7" on pagetip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 20171

Security Center System RequirementsSecurity Center 5.7 client station requirementsTo ensure that your client station runs optimally, it's important to know the minimum, recommended, andhigh performance requirements for a Security Center 5.7 client station.The requirements for Security Center 5.7 client stations are as follows:Client profileClient characteristicsMinimumRecommendedHigh performanceVideo intensive configuration Intel Core 2 X6800 @ 2.93 GHz 2 GB of RAM or better 80 GB hard drive for OS and Security Center applications 256 MB PCI-Express x16 video card 1280 x 1024 or higher screen resolution with 96 dpi 100 Mbps Ethernet network interface card 4 Generation Intel Core i7-4770 or better 8 GB of RAM or better 64-bit operating system 120 GB Solid State Drive for OS and Security Center applications GbE network interface card NVIDIA QUADRO K620 2 GB video card 4 Generation Intel Core i7-4770 or better 16 GB of RAM or better 64-bit operating system 240 GB Solid State Drive for OS and Security Center applications GbE network interface card 1 x NVIDIA GeForce GTX 1060 6 GB video card th th GPU considerations Minimum of 2 GB of video RAM recommended. If your Intel processors support Intel Quick Sync Video, then this technology can also be usedprovided the monitor is plugged into the motherboard. Laptops can also use Quick Sync Video. Two or more graphic cards can be used to support different monitors individually. To have the videodecoding done on the card, at least one monitor must be connected to each card. NVIDIA SLI bridge not supported. The decoding of H.265 HEVC video can be accelerated using an NVIDIA GeForce GTX 1060, GTX 1070,or GTX 1080 video card. tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 2017 2

Security Center System RequirementsMaximum number of cameras viewed per client typeTo ensure that your client workstation runs optimally, it is important to know the maximum number ofcameras that can be viewed per client station type in Security Center 5.7.The maximum number of cameras viewed per client station type in Security Center 5.7 are as follows:H.264 formatCIFVGAHDFull HDUltra HDResolution @ 30 fps352 x 240640 x 4801280 x 7201920 x 10803840 x 21601350 Kbps1 100 Kbps2 300 Kbps5 500 Kbps50 000 Kbps146210604723116785850268Average bit rate/cameraMinimumRecommended2High performance2, 3Video intensive configuration1These are estimates, and different camera manufacturer’s bit rate may vary with the same resolution andframe rate. The decoding performance can also vary from one manufacturer to another.2With hardware acceleration enabled.3Using one video card NVIDIA GeForce GTX 1060 with 6 GB of RAM Performance benchmark for HEVC (H.265)The following benchmark illustrates the average bit rate of a camera streaming at 20 fps using HEVC(H.265) video format. thThe viewing workstation has a 4 Generation Intel Core i7-4770 @ 3.5 GHz processor, with 16 GB RAM, an SSD hard drive, and runs Windows 8.1. The video card used is an NVIDIA GeForce GTX 1060 with 6 GBof RAM connected to a 4K monitor.H.265 formatVGAHDUXGAFull HDResolution @ 20 fps640 x 4801280 x 7201600 x 12001920 x 1080Average bit rate/camera115 Kbps445 Kbps730 Kbps3 000 Kbps77513124Max. number of camerasEncryption impact on workstation performanceVideo encryption can increase the CPU usage by up to 40% when viewing low resolution video (CIF). Theimpact becomes less noticeable as the resolution of the video increases, because much more processingpower is spent on decoding the video than on decrypting the video. The impact on performance becomesunnoticeable when viewing HD and Ultra-HD video.tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 20173

Security Center System RequirementsSecurity Center 5.7 server requirementsTo ensure that your system runs optimally, it's important to know the minimum, recommended, and highperformance server requirements for a Security Center 5.7 Directory, Archiver, and Access Manager.The requirements for Security Center 5.7 servers are as follows:Server profileServer characteristicsMinimumRecommended2High performanceVideo intensive configuration Intel Core 2 Duo E6850 3.0 GHz or better 4 GB of RAM or better 80 GB hard drive for OS and Security Center applications 32-bit operating system 100/1000 Mbps Ethernet network interface card Standard SVGA video card Quad Core Intel Xeon E5640 2.66 GHz or better 16 GB of RAM or better 64-bit operating system 80 GB SATA II hard drive or better for OS and Security Center applications GbE network interface card Standard SVGA video card BCDVideo Generation 9 Servers1 1BCDVideo Gen9 servers offer high performance for video intensive archiving,starting from 500 cameras or 500 Mbps, and 250 Mbps of video redirection, upto 700 cameras or 1300 Mbps, and 600 Mbps of video redirection.For BCDVideo solutions tailored to your requirements, contact Genetec Salesat [email protected], or call 1-866-684-8006 (option #2).1Config Tool requires a minimum resolution of 1024 x 768. Not required for virtual servers.2The intended throughput requires specific hardware and software configurations.tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 20174

Security Center System RequirementsMaximum number of cameras and readers per server typeTo ensure that your system runs optimally, it's important to know the maximum number of cameras andreaders per server type in Security Center 5.7.Server typeMinimumRecommended50 cameras or 50 Mbps100 cameras or 200 Mbps75 cameras or 75 Mbps300 cameras or 300 Mbps100 HID Edge readers/V2000, or 150 readers on HIDV1000/Synergis Cloud Link300 HID Edge readers/V2000, or300 readers on HID V1000 or 1024readers on Synergis Cloud Link10 HID V1000/Synergis Cloud Link100 HID V1000/Synergis Cloud Link10,000 cardholders250,000 cardholders100 HID Edge readers/V2000, or 150 readers on HIDV1000/Synergis Cloud Link700 HID Edge readers/V2000, or500 readers on HID V1000 or 2048readers on Synergis Cloud Link10 HID V1000/Synergis Cloud Link100 HID V1000/Synergis Cloud Link10,000 cardholders250,000 cardholders50 cameras or 50Mbps and 64 readers100 cameras or 200Mbps and 200 readers5 HID V1000/Synergis Cloud Link40 HID V1000/Synergis Cloud Link5,000 cardholders40,000 cardholdersDirectory & Archiver(Video only)Standalone Archiver1(Video only)Directory & AccessManager(Access control only)Standalone AccessManager(Access control only)Directory, Archiver &2Access Manager(Unified)1For high performance Archivers (500 cameras and up), see Security Center 5.7 server requirements onpage 4.2SQL server should be run on a separate machine when using a system meeting the minimumrequirements.Encryption impact on Archiver performanceThe first encryption certificate enabled on the Archiver will reduce the capacity of the Archiver by 30%.Each additional encryption certificate applied to all cameras further reduces the Archiver capacity by 4%.ExampleYour Archiver supports 300 cameras without encryption.Number of certificates enabled0 encryption certificates (no encryption)tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 2017Number of supported cameras300 cameras5

Security Center System RequirementsNumber of certificates enabledNumber of supported cameras1 encryption certificate210 cameras5 encryption certificates178 cameras10 encryption certificates145 cameras20 encryption certificates96 camerasBEST PRACTICE: Do not exceed 20 encryption certificates per Archiver.For more information on fusion stream encryption, see the Security Center Administrator Guide.tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 20176

Security Center System RequirementsSecurity Center 5.7 AutoVu LPR server requirementsTo ensure that your system runs optimally, it's important to know the minimum, recommended, and highperformance requirements for a Security Center 5.7 AutoVu LPR server.1The requirements for Security Center 5.7 AutoVu LPR servers are as follows:Server profileMinimum2RecommendedServer characteristics Intel Quad Core i5-3550 processor equivalent or better (6000 CPU Mark orbetter) 12 GB of RAM (minimum 4 GB dedicated to SQL Server) Separated storage disk from OS primary disk 50 AutoVu units (Sharp or Genetec Patroller combined) SQL Express database server containing up to 6 000 000 LPR Events (Reads andHits combined) Maximum of 5 simultaneous user connections Intel Quad Core i7-3820 processor equivalent or better (8000 CPU Mark orbetter) 16 GB of RAM (minimum 6 GB dedicated to SQL Server) Dedicated RAID5 storage with 4 enterprise grade disks or better 100 AutoVu units (Sharp or Genetec Patroller combined) SQL Standard database server containing up to 25 000 000 LPR Events (Readsand Hits combined) Maximum of 20 simultaneous user connections Intel Xeon Quad Core processor equivalent or better than E5-1620 v4 (10 000CPU Mark or better) 32 GB of RAM (minimum 8 GB dedicated to SQL Server) Dedicated RAID5 storage with at least 8 high performance enterprise gradedisks or better Up to 250 AutoVu units (Sharp or Genetec Patroller combined) SQL Standard database server containing up to 80 000 000 LPR Events (Readsand Hits combined) Maximum of 80 simultaneous user connectionsHigh performance 1These requirements are for installation on a single server. For higher performance, you can distribute theload on several servers.2SV-32 v2 equivalent machine.tip.genetec.com Security Center System Requirements Guide 5.7EN.500.100-V5.7.B(1) Last updated: Octber 16, 20177

Security Center System RequirementsSecurity Center 5.7 software requirementsTo ensure that your system runs optimally, it is important to know the software requirements for SecurityCenter 5.7.The requirements for Security Center 5.7 software are as follows:CategoryOperating systemsDatabase EnginesBrowsers for SecurityCenter Server AdminBrowsers for Synergis Appliance PortalBrowsers for Web Client5.7Supported software 1 Microsoft Windows 7 Pro/Enterprise/Ultimate SP1 Microsoft Windows 8.1 Pro/Enterprise Microsoft Windows 10 Pro/Enterprise 1 1 Microsoft Windows Server 2008 R2 SP1 22 Microsoft Windows Server 2012 Microsoft Windows Server 2012 R2 Microsoft Windows Server 2016 SQL Server 2008 R2 Express/Standard/Enterprise SQL Server 2012 Express/Standard/Enterprise SQL Server 2014 Express/Standard/Enterprise SQL Server 2016 Express/Standard/Enterprise Internet Explorer 9, 10, and 11 Chrome 46 (or later) Firefox 42 (or later) Safari 9 (or later) Microsoft Edge 25 (or later) Internet Explorer 9, 10, or Google Chrome Internet Explorer 11 or higher Edge for Windows 10 Chrome Firefox Safari (desktop version) 22,33 tip.genetec.com Security Center System Requirements Gu